Chamfer panels are in place

October is over as well as another step in my boatbuilding process:
Inner panels are in place.
It took me a month to fabricate and glue the panels in.

Port side

Starboard side

Front crossbeam/bridgedeck

2000mm bulkhead

500mm bulkhead

Inner view

Chain plate bulkhead

End of September 2011.

Chain plate bulkhead is in place.




Cockpit seat. View from saloon.

 

Daggerboard case cut-out

Last summer I built two daggerboard cases mock-ups from cheap EPS foam and then I make a starboard cut in order to install the daggerboard case.

You could see details on pictures below.

10000mm bulkheads

10000mm bulkheads are in place.

And rear panel for cockpit seat has been glassed as well.

Starboard bulkhead

Rear seat panel glassed

Rudder's hardware

My  inventory:

Last spring I’ve got titanium rudder shafts with derlin gliding bushings (thanks Dad!),  as well as bulkhead steerer case and steering wheel hub with a stainless steel shaft.

So, the next step (when I`m done with glassing the hull in my shed for the season) is gonna build a pair of rudders in my garage.

Forward crossbeam panels

August 2011.
I vacuum bagged and installed few panels for the front crossbeam.
I also changed the shape of D-panels to made kid's berths a bit wider.
It allows accommodating twin-size mattresses for both of them.

You can see the changes
being made there.



Saloon bulkheads

Two saloon bulkheads were glued in at the mid of August, 2011.

Overall view

Starboard panel